PARTICLES PINNATE

   * Subject: Re: Particles Question / Help
   * Date: Sat, 28 May 1994 12:36:01 -0700 (PDT) [50]
   * From: "Randy R. Wall" <rrw@ecst.csuchico.edu>

The actual particle effect worked great though! all the shperes fell off the logo making the logo fall apart and then they hit the ground and bounce...I set the Elasticity to 50 which caused them to bounce when they hit the ground which was set at 0...you also should remember to set the "time to terminal Z and H velosity to the amount of frames you wish for the effect to take place..these control the amount of frames it takes for the effect to take its full effect..at least as far as your particle distribution is concerned. I used Delayed/bounce and set the travel distance to 500 as my logo was that high above the ground..you would want 100 for what you are talking about.. hope this helps you out a bit..all of the other settings are at your discretion...

                         -> Return to Alphabet <-

Back to Ian Smith's HomePage

Contents page

Index

PARTICLES PINNATE